白鐵皮加工/大渡口白鐵皮加工 白鐵排風管安裝的要求：
1) 白鐵排風管穿牆時使用不燃保溫材料封堵如岩棉。
2) 白鐵排風管設備時其內應邊設備邊穿尼龍線，以便于緊密性檢查時拖動行燈檢查，緊密性檢查前應準備150W平安行燈與至少50米電線。
3) 編號時應注明體系稱謂層別;;序號;;斷面標準;;每節長度等。
4) 白鐵排風管支吊架設備時脹大栓孔深度為脹大螺栓導管長度加1~1.5CM 。
5) 白鐵排風管支架及白鐵排風管設備時應拉線設備，以便于設備終了調整直線度與平面度。白鐵排風管吊杆應筆直，一致標準白鐵排風管的吊杆應在一條長度偏向直線上。
6) 白鐵排風管設備調直後應就法蘭聯接部位從新用阻燃密封膠密封。
7) 白鐵排風管吊杆與托架聯接時固定螺母托架上部一個;;下部兩個，並加防振橡膠墊厚10MM ，以防白鐵排風管振動時螺母松動。
8) 較長的管道有高差改變時，應在低處應根據客觀實習情況設置接水盤，並有水封。(由技術擔任人定)Tin tin tin processing / Dadukou processing exhaust pipe installation requirements:
1) tin exhaust pipe through walls using non combustible insulation materials such as rock wool block.
2) tin exhaust pipe equipment when the internal edge of side wear nylon line, in order to facilitate the close examination drag row lamp examination, close inspection should be prepared before the 150W safety lamp and at least 50 meters of wire.
3) the number of the system should be noted that the layers of the title;; serial number; cross section standards; the length of each section, etc..
4) exhaust tin pipe hanger equipment when the hole depth swell swell bolt length 1~1.5CM.
5) cable equipment should be galvanized iron exhaust pipe bracket and tin exhaust pipe equipment, equipment for the end of straightness and flatness adjustment. Tin exhaust pipe hangers should be straight, the consistent standard tin exhaust pipe should be in a straight line length bias.