照明产品新ErP及能效标签法规修正
New ErP & Energy Label Regulation for
Lighting products revision
2021年2月26日，欧盟发布了 (EU) 2021/341 和 (EU) 2021/340 两条新指令，其中分别针对原指令 (EU) 2019/2020 光源和独立式控制装置生态设计要求和 (EU) 2019/2015 光源能效标签要求做了相应的修正，为新版ERP发布以来第一次重大更新。On February 26, 2021, the European Commission issued two new directives (EU) 2021/341 and (EU) 2021/340, which respectively address the original directive (EU) 2019/2020 light source and separate control gears ecological design requirements and (EU) The 2019/2015 energy labelling requirements for light sources have been revised accordingly, which is the first major update since the release of the new version of ERP.
新指令(EU) 2021/341修正New directives (EU) 2021/341 revised
1、 新增条款：如果在2021-07-01之前，市场上未投放相同产品，那么在2021-07-01至2021-08-31之间，满足新版ERP指令 (EU) 2019/2020要求的产品，视为满足旧版ERP指令 (EC) No 244/2009，(EC) No 245/2009及 (EU) No 1194/2012的要求。If no unit belonging to the same model or equivalent models was placed on the market before 1 July 2021, the units of models placed on the market between 1 July 2021 and 31 August 2021 which comply with the provisions of this regulation shall be considered compliant with the requirements of Commission Regulations (EC) No 244/2009, (EC) No 245/2009 and (EU) No 1194/2012.’;
2、 新增条款：针对已投放市场的产品，对硬件及软件升级做了相应的管控。For the products that have been placed on the market, the hardware and firmware upgrades have been controlled accordingly.
- 任何硬件和软件升级不得降低产品的能效The energy consumption of the product and any of the other parameters shall not deteriorate after a software or firmware update
- 任何软件升级需保证产品仍符合ERP指令要求Any software update shall ensure that the product still meets the requirements of the ERP directive
- 拒绝软件升级不得影响产品原有性能A software update shall never have the effect of changing the product's performance
3、 对原有豁免产品进行修正; Revise the original exempted products;
4、 对部分产品测试要求做了变更：用于 冰箱、洗碗机、洗衣机/洗干一体机、 烘干机内的光源，将不再需要满足ANNEX II中光通量维持率，存活率的要求；外包装及技术文件内不再需要体现寿命，光通量维持因数，存活因数等信息。Light sources specifically designed and exclusively marketed for use in products in the scope of Commission Regulations 2019/2023, 2019/2022, 932/2012 and 2019/2019, shall be exempt from the requirements regarding lumen maintenance factor and survival factor
5、 Annex II 修改如下：Annex II is amended as follows:
修订前：
SVM≤0.4
除了有效光通量大于4klm的HID，或者用于室外环境，工业环境或其余环境当光源标准允许显色指数小于80
修订后：
SVM≤0.9
SVM≤0.4 (2024年9月1日后)
除了有效光通量大于4klm的HID，或者用于室外环境，工业环境或其余环境当光源标准允许显色指数小于80
新指令(EU) 2021/340修正New directives (EU) 2021/340 revised
1、 修正原版效等级标签尺寸错误revised label size
标准标签尺寸由“至少36mm x 75mm ”修正为至少“36mm x 72mm” for the standard-sized label, at least 36 mm wide and 72 mm high
小标签尺寸for the small-sized label (width less than 36 mm), at least 20 mm wide and 54 mm high
- 新增了对能效等级标签边框的要求the rectangular border of the label and the internal dividers shall have a weight of 0,5 pt and the colour shall be 100 % black’;
1、 注册信息变更Registration information revision：
- 新增灯头 / 连接端口类型 Added Light source cap-type (or other electric interface)
- 能源消耗数值（kWh/1000h）改为向上取整Energy consumption in on-mode (kWh/1 000 h), rounded up to the nearest integer
- 对色温的录入格式做了调整Adjusting Input Format for CCT
2、 技术文件内新增信息Added information in technical document ：
- 定向灯峰值光强Peak luminous intensity in cd for directional light sources
- LED和OLED产品R9数值R9 colour rendering index value for LED and OLED light sources
- LED和OLED产品存活因数Survival factor for LED and OLED light sources;
- LED和OLED产品光通量维持因数Lumen maintenance factor for LED and OLED light sources
- LED和OLED产品宣称寿命（L70B50）Indicative lifetime L70B50 for LED and OLED light sources
3、 市场抽查要求变更Market surveillance requirement revision ：
- 若PST短期闪烁指数及SVM频闪效应的宣称值小于等于1.0，验证公差范围从“实测值不超过宣称值10%”改为“实测值不超过宣称值+0.1”
- 移除针对FL和HID存活率及光通量维持率的要求Removed requirements for FL and HID Survival factor and Lumen maintenance factor